Description

Wilbur Curtis

Authorized Distributor

Model:  G4TPX2S63A3100

Wilbur Curtis G4 ThermoProX 1.5 Gal. Single Coffee Brewer

Coffee Machine Depot USA is proud to present the Wilbur Curtis G4 ThermoProX Single 1.5 Gallon Coffee Brewer. The G4 ThermoProX Brewer provides precise control over all aspects of brewing including time, temperature, and volume. Equipped with G4 Interface and a 4.3” touch screen. It’s modern with an elegant sleek look and an easy to clean design.  It is the industry’s most effective mineral tolerant design.

*** DISPENSER NOT INCLUDED ***

FEATURES AT A GLANCE

• Generation Four (G4) Digital Control Module – Large, 4.3” touch screen. Icon-driven interface streamlines operation.
• Built-in Self Diagnostic System – Includes real-time feedback of the brewing process and energy saving mode.
• Gold Cup Series™ – Digital Control Module provides precise control over all aspects of brewing: time, temperature, volume plus specialty coffee needs from pre-infusion to pulse- brewing to water bypass.
• Pre-set, One-Touch Global Recipes – Based on coffee type, grind weight. Simplifies profile setting for gourmet results every time.
• Single unit is field selectable for One, Two or Three Batch brewing.
• Centrally located hot waterspout for instant hot beverages and other hot water needs.

DIMENSIONS

Height (in.) 36.480”

Width (in.) 11.000”

Depth (in.) 19.720”

ELECTRICAL

Phase 1

Volts 120/220

Amps 15.0/12.7

Heat Configuration 2x1600

Wire 2W+G/3W+G

Watts 1800/2800

Hertz 50/60

WATER

Connector 3/8” Flare

Pressure 20-90 psi

Min. Flow Rate 1

Tank Volume 2.9

SHIPPING

Ship Height (in.) 37.00”

Ship Width (in.) 18.00”

Ship Depth (in.) 25.00”

Ship Weight 53 lbs

Ship Cube 9.7 cuft

GENERAL

Certification: UL/ NSF

Warning: Proposition 65 Warning — Applies to the State of California Only. LEARN MORE 

Installation Requirements

1. A secure surface capable of supporting the weight of the appliance.
2. For units without an attached cord set: Appropriately sized, UL listed, grounding type power cable to meet the electrical specifications for the appliance. If you have questions about the correct cable size and length, consult a qualified installer. If the unit will be hard wired to a junction box, the power cable must be long enough so that it can be moved for cleaning underneath.
3. A grounded electrical connection to an electrical circuit that meets the electrical specifications of the appliance (see SPECIFICATIONS). The circuit must be protected by the appropriate sized circuit breaker. If you are not certain that the existing circuit meets the requirements for your unit, consult a licensed electrician.
4. A water filtration system is required to maintain trouble-free operation.
5. Potable water supply line connection from the water filter capable of supplying the minimum flow rate required by the specifications. The water supply line must be able to connect to the flare fitting on the back of the unit. See the SPECIFICATIONS section for the correct size. The water line should also be capable of being controlled by a shut off valve. Do not connect the water line to a saddle or needle valve.