Description

Wilbur Curtis

Authorized Distributor

Model:  CBHS

Wilbur Curtis Single Hi-Volume Combo Brewer

Now you can brew delicious, iced tea and rich, robust coffee from the same precision system. Simply add bulk tea leaves, flow-thru filter packs or ground coffee, then press the clearly marked brew button for gallons of cool, flavorful iced tea or rich coffee in just minutes.

***DISPENSER SOLD SEPERATELY*** 

FEATURES AT A GLANCE

• Generation Four (G4) Digital Control Module – Large, 4.3" touch screen
• Multiple Beverage Options – Designed to brew up to 1.5 gallons of hot coffee or up to 3.0 gallons of iced tea or iced coffee within seconds
• "Fast Brew" Option
• Cold Brew Lock Out
• On-Screen Instructions – Provides fast, intuitive training; reduces service calls
• Encapsulated Control Board – Protects against steam, water and impact
• Built-in Self Diagnostic System

DIMENSIONS

Height (in.) 36.710”

Width (in.) 10.070”

Depth (in.) 22.610”

ELECTRICAL

Phase 1/1

Volts 120/220

Amps 15.0/12.7

Heat Configuration 2 x 1600W

Wire 2W+G/3W+G

Watts 1800/2800

Hertz 50/60

 This is a dual voltage item that can be used in 120 or 220 Volts. Amperage and wire specifications need to match according to the voltage being used. If you have any questions, please contact a licensed electrician for clarification on what your facility requires. Refer to specifications above for clarification on the requirements.

WATER

Connector 1/4” Flare

Pressure 20-90 psi

Min. Flow Rate 1.0 GPM

Tank Volume 2.9 Gal

SHIPPING

Ship Height (in) 44.00”

Ship Width (in) 14.00”

Ship Depth (in.) 26.00”

Ship Weight: 44.00 lbs

Ship Cube: 9.27 cuft

GENERAL

Certification: UL/ NSF

Warning: Proposition 65 Warning — Applies to the State of California Only. LEARN MORE >

Installation Requirements

1. A secure surface capable of supporting the weight of the appliance.
2. For units without an attached cord set: Appropriately sized, UL listed, grounding type power cable to meet the electrical specifications for the appliance. If you have questions about the correct cable size and length, consult a qualified installer. If the unit will be hard wired to a junction box, the power cable must be long enough so that it can be moved for cleaning underneath.
3. A grounded electrical connection to an electrical circuit that meets the electrical specifications of the appliance (see SPECIFICATIONS). The circuit must be protected by the appropriate sized circuit breaker. If you are not certain that the existing circuit meets the requirements for your unit, consult a licensed electrician.
4. A water filtration system is required to maintain trouble-free operation.
5. Potable water supply line connection from the water filter capable of supplying the minimum flow rate required by the specifications. The water supply line must be able to connect to the flare fitting on the back of the unit. See the SPECIFICATIONS section for the correct size. The water line should also be capable of being controlled by a shut off valve. Do not connect the water line to a saddle or needle valve.