Description

Wilbur Curtis

Authorized Distributor

Model:  G4RTB

Wilbur Curtis G4 Tea Brewer with Rotating Basket Tea

Curtis iced tea brewers have long been an industry benchmark. Featuring ingenious design, units help c-stores, restaurants and other foodservice operators save time, increase efficiency, and improve profitability. Models come in a variety of sizes and configurations to meet any need. Customers can also select from a selection of stainless-steel iced tea dispensers in many sizes and shapes.

*** DISPENSER NOT INCLUDED ***

FEATURES AT A GLANCE

• Generation Four (G4) Digital Control Module
• Large, 4.3” Touch ScreenIcon-Driven Interface
• Easily Brew Multiple Teas from One Brewer
• Rotating Brew Basket and Dual Dilution Spouts
• “Fast Brew” Option
• Easily Adjust Time, Volume, Temperature and More
• Cold Water Brew Lock Out
• Built-in Self Diagnostic System

DIMENSIONS

Height (in.) 34.290”

Width (in.) 13.160”

Depth (in.) 22.960”

ELECTRICAL

Phase 1

Volts 120

Amps 13.8

Heat Configuration 1x1600W

Wire 2W+G

Watts 1650

Hertz 50/60

WATER

Connector 1/4” Flare

Pressure 20-90 psi

Min. Flow Rate 1.0 GPM

Tank Volume 1.6 Gal

SHIPPING

Ship Height (in) 38.00”

Ship Width (in) 15.00”

Ship Depth (in.) 27.00”

Ship Weight: 41.00 lbs

Ship Cube: 9.14 cuft

GENERAL

Certification: UL/ NSF

Warning: Proposition 65 Warning — Applies to the State of California Only. LEARN MORE >

Installation Requirements

1. A secure surface capable of supporting the weight of the appliance.
2. For units without an attached cord set: Appropriately sized, UL listed, grounding type power cable to meet the electrical specifications for the appliance. If you have questions about the correct cable size and length, consult a qualified installer. If the unit will be hard wired to a junction box, the power cable must be long enough so that it can be moved for cleaning underneath.
3. A grounded electrical connection to an electrical circuit that meets the electrical specifications of the appliance (see SPECIFICATIONS). The circuit must be protected by the appropriate sized circuit breaker. If you are not certain that the existing circuit meets the requirements for your unit, consult a licensed electrician.
4. A water filtration system is required to maintain trouble-free operation.
5. Potable water supply line connection from the water filter capable of supplying the minimum flow rate required by the specifications. The water supply line must be able to connect to the flare fitting on the back of the unit. See the SPECIFICATIONS section for the correct size. The water line should also be capable of being controlled by a shut off valve. Do not connect the water line to a saddle or needle valve.