Description

Wilbur Curtis

Authorized Distributor

Model:  RU-600-12

Wilbur Curtis Twin 6.0 Gallon Automatic Coffee Urn

With almost 80 years of heritage in the industry, you can’t beat Curtis for commercial coffee brewers that ensure consistently delicious, quality coffee. With units that specialize in batch brewing, single cup brewing, ultra-high volume brewing, satellite brewing, thermal coffee systems and everything in between, you’ll find state-on-the-art commercial coffee equipment that delivers user-friendly operation and precise control over all brewing functions.

FEATURES AT A GLANCE

• Automatic refill during brew cycle.
• Thermostatically controlled for near-instant recovery.
• Closed-lid brewing creates superior flavor and full coffee aroma.
• Electric or gas.
• Swing-spray head evenly saturates coffee grounds for complete extraction.

DIMENSIONS

Height (in.) 31.270”

Width (in.) 38.430”

Depth (in.) 22.170”

Cup Clearance (in.) 10.25

ELECTRICAL

Phase 1

Volts 220

Amps 45.5

Heat Configuration 2 x 5000W

Wire 3W+G

Watts 10000

Hertz 50/60

FOR SAFETY REASONS A POWER CORD IS NOT INCLUDED.Please note that this brewer requires a 240 volt 3W+G wall receptacle (commercial plug). Please see specifications above. We recomend that you contact a professional to ensure that you have the requirements to properly connect and operate this unit. Feel free to give us a call if you have any questions regarding these requirements.

** Also available in 3 Phase. Contact us to special order **

WATER

Connector 1/4” Flare

Pressure 20-90 psi

Min. Flow Rate 1.0 GPM

Tank Volume 23.0 Gal

SHIPPING

Ship Height (in) 31.00”

Ship Width (in) 24.00”

Ship Depth (in.) 45.00”

Ship Weight: 120.00 lbs

Ship Cube: 19.37 cuft

GENERAL

Certification: UL/ NSF

Warning: Proposition 65 Warning — Applies to the State of California Only. LEARN MORE >

Installation Requirements

1. A secure surface capable of supporting the weight of the appliance.
2. For units without an attached cord set: Appropriately sized, UL listed, grounding type power cable to meet the electrical specifications for the appliance. If you have questions about the correct cable size and length, consult a qualified installer. If the unit will be hard wired to a junction box, the power cable must be long enough so that it can be moved for cleaning underneath.
3. A grounded electrical connection to an electrical circuit that meets the electrical specifications of the appliance (see SPECIFICATIONS). The circuit must be protected by the appropriate sized circuit breaker. If you are not certain that the existing circuit meets the requirements for your unit, consult a licensed electrician.
4. A water filtration system is required to maintain trouble-free operation.
5. Potable water supply line connection from the water filter capable of supplying the minimum flow rate required by the specifications. The water supply line must be able to connect to the flare fitting on the back of the unit. See the SPECIFICATIONS section for the correct size. The water line should also be capable of being controlled by a shut off valve. Do not connect the water line to a saddle or needle valve.